Free Cisco 300-425 ENWLSD Actual Exam Questions - Question 8 Discussion
company’s building still run on the legacy WLC. The new WLC is not located at the same site as the
legacy WLC. The company requires seamless client inter-controller roaming between the new WLC
and the legacy WLC, with no disruptions. Both WLCs are separated by firewalls. Which
troubleshooting command validates that
the mobility control packets between the WLCs can be
sent and received?
Option A makes sense since it directly tests if the mobility control packets can reach the other WLC, which is key when firewalls might block them. Debug commands just show what’s happening but don’t confirm connectivity.
Maybe A makes more sense here since the question emphasizes validating if mobility control packets can be sent and received. Debug commands show traffic but don’t necessarily confirm baseline connectivity, which A’s mapping command checks.
A/D? Mapping commands check connectivity; D might be too new for legacy WLC.
It’s A because mapping mobility_peer IP checks the basic control communication path between WLCs, which is crucial for mobility packets across firewalls. Debug commands show activity but don’t confirm connectivity.
B imo, debug mobility handoff enable shows actual packet flow during roaming.
A, because mobility_peer IP is often used for both data and control even on older WLCs.
I’m leaning towards D because mobility_peer_management IP is usually used for control traffic between WLCs. It makes sense to check that path for mobility control packets. Anyone else think A could work too?