Free Juniper JN0-460 Actual Exam Questions - Question 2 Discussion
What are two possible device states that the switch will have in this scenario? (Choose two.)
B and C, since claiming activates but doesn’t guarantee connection yet.
B/D? If the switch just got claimed, it might not be fully activated or connected yet, so inactive and unassigned could both apply while it’s still setting up.
B and C imo, claiming should make it active but not necessarily connected yet.
B/C? Claimed means it’s registered and ready but not necessarily connected, so inactive and active states both seem possible before actual network connection is established.
B/D? The switch is claimed but might not be active or connected immediately, so inactive and unassigned fit the early stages better than active or connected here.
Maybe B and D here. Claiming the switch assigns it, so it’s not active (C) or connected (A) yet, but it could still be unassigned or inactive depending on the exact timing.
B/D? Claiming the switch assigns it but might not fully activate it, so inactive and unassigned both make sense before any active connection happens. A and C feel like later stages.
It’s B and D. Claiming might not instantly activate the switch, so it can still be inactive, and some systems keep it as unassigned until the connection is confirmed. C and A imply full activation or connection, which isn’t guaranteed yet.
B/C for sure, claiming activates it but connection isn’t guaranteed yet.
Maybe B and C work here since claiming the switch should move it out of the unassigned state, but it might still be inactive before connecting. So definitely not D once claimed.
B and C fit since claiming activates the device but doesn’t guarantee connection yet.
It’s B and C. Once claimed, the device is recognized by the org (so not unassigned), but it might still be inactive until it’s fully configured or connected.
I think the switch would be either B (Inactive) or D (Unassigned) right after claiming with the activation code, before it fully connects.